Roland VS-640i - Page 55

53
Chapter 3 Printing Chapter 3 Printing
3-5 Starting the Print Operation

Click , congure the settings in [Qual-
ity Settings] and [Color Management].
* For details on settings, refer to the followings.
 P. 24, "3-2 Print Job Setting : Equipped with White & Silver"
 P. 41, "3-3 Print Job Setting : Equipped with Silver Only"
Click [OK].

Click [Media] and then [Metallic Color
Chart].
Check the page size.
If the size of the media loaded on the printer is not
adequate for the page size, change it to another
media of sucient size.
Click [OK].
The print job of the Metallic Color Chart is added to
the job list.

Click .
Printing will be started.
When printing a Metallic Color Chart, the [Quality] settings from the [Queue Properties] win-
dow are always applied. Since you cannot change the quality settings for the job using the
[Job Settings] window after it has been added, be sure to congure the settings in the [Queue
Properties] window before performing the following operations.
VS-640i_USE2_EN_R1.indb 53 2013/07/23 19:00:31