Roland VS-640i - Performing Metallic Texture Printing: Equipped with Silver; What Is Metallic Texture Printing; Printing a Metallic Texture Chart

56
Chapter 4 AdvancedChapter 4 Advanced
4-1 Performing Metallic Texture Printing: Equipped with Silver
What is Metallic Texture Printing?
Metallic texture printing is dened as the method of producing texture patterns with metallic silver ink. This
uses the texture patterns provided by "Metallic Texture System Library" to create and output print data. This
document describes the method of the texture printing that uses metallic silver ink.
* Create the printing data using the Adobe Illustrator version of CS or later if using Adobe Illustrator. If you
use the earlier version before Adobe Illustrator 10 to create the printing data, the texture patterns may
result in poor condition.
Printing a Metallic Texture Chart
The chart that works as print sample of metallic texture is provided. Printing the chart allows you to check the
"complete metallic texture chart" showing the metallic texture patterns available with printing in the com-
bination of "Your Printer" and "Your Media." (Depending on the conditions of the printer and media, there is
a slight dierence in pattern.) By creating print data with the texture pattern you select in this chart, you can
print your intended pattern almost perfectly.
* To print a chart, use the same media as the one actually going to be used.
Procedure

Double-click .
"Queue A Properties" window appears.
* Metallic texture chart output is available with
Queue A only.

Click , congure the settings in [Qual-
ity Settings] and [Color Management].
* For details on settings, refer to the followings.
 P. 24, "3-2 Print Job Setting : Equipped with White & Silver"
 P. 41, "3-3 Print Job Setting : Equipped with Silver Only"
Click [OK].
Note: When printing a metallic texture chart, the [Quality] settings from the [Queue Properties] window are
always applied. Since you cannot change the quality settings for the job using the [Job Settings] window after
it has been added, be sure to congure the settings in the [Queue Properties] window before performing the
following operations.
VS-640i_USE2_EN_R1.indb 56 2013/07/23 19:00:31