Roland VS-640i - 4-2 Maintenance Procedures

60
Chapter 4 Advanced Chapter 4 Advanced
4-1 Performing Metallic Texture Printing: Equipped with Silver
2. Create illustrations and specify texture patterns you wish to use

Create the illustration.
Be sure to draw the illustration in the CMYK mode.

Assign the desired texture patterns to the areas for the metallic texture printing.
Using the chart printed in P. 56, "Printing a Metallic Texture Chart", check the texture patterns and specify
a desired one. As there is a slight dierence in color and pattern according to media, be sure to check
colors and patterns in the chart printed on the media same as the one that you are actually going to use.
The areas where the texture patterns are assigned shall be printed with metallic silver ink. When the
metallic silver ink is to be used for the printings other than the texture printing, other special spot colors
shall be used. For the detailed usage, please refer to P. 9, "Chapter 2 Getting Ready".
* The name of the texture pattern is displayed on the data of Illustrator. The texture of the displayed image
appears rougher than that of the actual print.
3. Create the PS (PostScript) le.
Create a PS le as referring to the steps of the procedure 3. in "Creating Data for Printing" in pages 15 to 17.
The area to be printed with the metallic texture

From "Roland Metallic Texture System Library," specify
the texture pattern such as RTSL-MT-Standard-020.
VS-640i_USE2_EN_R1.indb 60 2013/07/23 19:00:32