30
VS-880EX Application Guide
Important Navigational Rules & Skills to Master
[PLAY (DISPLAY)] Button
Use the [PLAY (DISPLAY)] button (directly below the bottom right hand corner of the LCD display) to
escape from the current command. For example, if you are lost or confused about where you are, press the
[PLAY (DISPLAY)] button to return to a ‘safe’ position and start over.
When used with the [SHIFT] button, it toggles the LCD to different displays (see Owner’s Manual page
163).
Transport Buttons
The Transport buttons operate the internal recorder section of the VS-880EX (Play, Stop, Record, Rewind,
Fast Forward, and Return to Zero).
[SHIFT] Button
Use the [SHIFT] button to access ‘white box’ commands.
Press and hold the [SHIFT] button whenever you want to access a VS-880EX command which is indicated
on the front panel by a white outline box with internal white lettering (for example: SONG END). To locate
to the SONG END, hold down the [SHIFT] button and press the [SONG END] button.
[CH EDIT] Buttons
Use the [CH EDIT] button to select a specific channel to edit.
Press the [CH EDIT] button to instruct the VS-880EX which track you want to work with. For example, if
you want to change the virtual track on channel 4, you would first press the [CH EDIT] button above fader
# 4 to select channel # 4 for editing. Then press [SHIFT] + [VTrack] (CH EDIT button # 2) to select the
Virtual Track parameter to edit. Then use the Time/Value dial to select the VTrack of choice.
[STATUS] Buttons
The Channel Status buttons are used to toggle each channel between four operational modes:
SOURCE Listen to the incoming source plugged into the rear panel.
REC Place track into record ready mode.
PLAY Place track into playback mode.
MUTE Turn channel off.
[PARAMETER] Buttons
Use the [PARAMETER] buttons to change screens (pages) in the LCD display.
To Next Page
Loading...
