63
Chapter 3: Recording Applications
Using the Serial Insert Path
The serial insert FX path routing allow you to send the same mono channel thru both the left and
right sides of a stereo effect. This is useful, for example, for using a four band stereo EQ as an eight
band mono EQ. This will allow you to make more precise EQ adjustments on your mono signal.
ACTION: Use the Serial Insert Path to Create an 8 Band
Parametric EQ
1. Press the [FADER/EDIT] button until it lights green.
1. Hold SHIFT and press EFFECT-1 [CH EDIT button 7]. Press the left [PARAMETER]
button until “EFF 1 INSERT SW” is displayed.
2. Press the CH EDIT button that corresponds to the track that you want to EQ.
3. Use the TIME/VALUE dial to select “InsertS.”
4. Press EFFECT (under EDIT CONDITION) until “EFFECT-1 PRM?” is displayed.
5. Use the TIME/VALUE dial to select “B93=ParametricEQ” and press YES/ENTER.
6. Use the PARAMETER buttons and the TIME/VALUE dial to adjust the EQ settings
for Input A and B. The signal will be processed by the Input A settings before being
routed to Input B. This, in essence, creates an 8-band parametric EQ.
This procedure requires a mono signal. Make sure that Channel Link
is set to “Off” for the designated channel (see Owner’s Manual page 149).
To Next Page
Loading...
