Roland VS-880EX - Page 83

83
Chapter 5: Editing Applications
(Use {Move} To Place Guitar Part in New Location, Continued)
9. Press the [STATUS] button that corresponds to the track you want to move this section of
the music to (this can be the same as the source track) so it is flashing red.
10. Use the TIME/VALUE dial to select the Virtual Track that you want to move the section to.
11. Repeat steps 8-10 to select additional Tracks as desired.
12. Press the right [PARAMETER>>] button, “TRK St.=” should be displayed.
13. Press [LOC 1].
14. Press the right [PARAMETER>>] button, “TRK Frm=” should be displayed.
15. Press [LOC 2].
16. Press the right [PARAMETER>>] button, “TRK End=” should be displayed.
17. Press [LOC 3].
18. Press the right [PARAMETER>>] button, “TRK To=” should be displayed.
19. Press [LOC 4].
20. Press the right [PARAMETER>>] button, “Track Move OK ?” should be displayed.
21. Press [YES] to complete the {Move} command.
Moving within the same track.
AA
Start End To Time
Moving to a different track.
B
B
Start End To Time
Moving using the “Frm” setting.
C
C
Start End To Time
From