86
VS-880EX Application Guide
What if you have a song with 3 chorus sections but you have the perfect background vocals recorded on Tr.
6-1 for the first chorus only? It would be extremely helpful to be able to use the first chorus background
vocals for the other 2 chorus sections.
Again using the {COPY} command, you can select the first chorus recording on tracks Tr. 6-1 as the
‘START’ and ‘END’ of the section to be copied. You can then instruct the VS-880EX to {COPY} this
background vocal section to the second and then to the third chorus. You will first specify the beginning of
the second chorus as your COPY TO location and then choose the third chorus as the COPY TO location
(for more - see the VS-880EX Owner’s Manual, Chapter 6).
ACTION: Use {Copy} To Re-Use A Vocal Background In
Multiple Verses
Clear Locate Points First: Hold the [CLEAR] button and press any [LOC] buttons with lit LED.
1. Set a Locate point with [LOC 1] at the beginning of the chorus # 1.
2. Set a Locate point with [LOC 2] at the end of the chorus # 1.
3. Set a Locate point with [LOC 3] at the beginning of chorus # 2
4. Set a Locate point with [LOC 4] at the beginning of chorus # 3.
5. Press [TRACK] until “Track Copy?” is displayed.
6. Press [YES].
7. Press [NO] repeatedly until “?-?>?-?” is displayed (to clear previous track selections).
8. Press the [SELECT] button that corresponds to the first track you want to copy from.
9. Press the [STATUS] button that corresponds to the Track you want to copy to (this can be
the same as the original source track) so it is flashing red.
10. Use the TIME/VALUE dial to select the destination Virtual Track.
11. Repeat steps 8-10 to select additional Tracks as desired.
You can only use those tracks and Virtual Tracks that are “on top” or ready
to play as source tracks for copying. If you want to copy a Virtual Track that
is below a currently playing track, you must first make that Virtual Track the
current playable track (see Owner’s Manual page 49 - Switching V-tracks).
12. Press the right [PARAMETER>>] button, “TRK St.=” should be displayed.
13. Press [LOC 1].
14. Press the right [PARAMETER>>] button, “TRK Frm=” should be displayed.
15. Press [ LOC 1].
16. Press the right [PARAMETER>>] button, “TRK End=” should be displayed.
17. Press [LOC 2].
18. Press the right [PARAMETER>>] button, “TRK To=” should be displayed.
19. Press [LOC 3] (the beginning of chorus # 2).
(Continued)
Use {Copy} To Re-Use A Vocal In Multiple Verses
To Next Page
Loading...
