4
Use the TIME/VALUE dial to select the type of effect (Patch).
Here, let’s select “A41 GT:Rock Lead.”
5
After selecting the effect, press [YES].
6
Press [FADER (EDIT)] several times to let the FADER indicator
light orange. (Input Mixer)
7
Press channel 1 [CH EDIT].
The upper left of the display will indicate “CH1,” allowing you to make settings
for channel 1.
8
Press PARAMETER [ [ ] to let “FX1 Ins=” appears in the
upper line of the display.
9
Use the TIME/VALUE dial to turn the effect on and off. Here,
select “Insert” to apply effect to the input source of the INPUT 1
jack.
10
Now it is set up. Press [PLAY (DISPLAY)].
The initial display reappears.
11
Hold down [REC] and press the Track 1 STATUS button.
The STATUS indicator blinks red.
12
Record and check the content by following the procedure
described in “Recording to the Tracks” (p. 15).
To Next Page
Loading...
