6-6 Making Various Adjustments for Cutting
99
Chapter 6 Feature Reference
Accurately Adjusting the Cutting-in Amount
When you want to perform accurate and fine adjust-
ment of the cutting-in amount, such as when cutting
media with thin carrier paper, you can obtain good
results by adjusting the tip of the blade.
Turn the cap portion of the blade holder to adjust the
amount of blade extension. Each indicator tick corre-
sponds to 0.1 millimeters, and adjustment for 0.5 mil-
limeters can be made by rotating the cap one full turn.
Note that making the amount of blade extension too
small may cause the end of the cap for the blade holder
to touch and damage the printed surface. It's impor-
tant to be especially careful about this when you're
using media that has poor ink-adhesion properties.
Rough Estimate for the Amount of Blade Extension
Use the following dimension as a rough estimate for setting the amount of blade extension.
Making the Cutting Conditions Set on the Machine Take Precedence
Procedure
➊
Press .
Press
.
➋
Press .
Press
twice.
➌
Press .
Use
to select "MENU."
Press
to enable the setting.
➍
Press .
Press
to go back to the original screen.
Description
You can also make the settings for the cutting conditions using the computer. By default, the settings made with the
computer take priority. To make the cutting conditions set on the machine take priority, either turn off the settings of
the computer or make the setting described above.
Amount of blade
extension
=
Thickness of the
media portion
Thickness of the
carrier paper
2
+
Amount of blade extension
Min. 0 mm Max. 2.5 mm
Holder
Half of the
carrier paper
Amount of blade
extension is approxi-
mately equal to the
cutting-in amount.
Blade
Carrier-paper
portion
Material
portion
W 1346mm
SETUP SHEET
ROLL
MENU
CUTTING MENU
CUTTING MENU
CUTTING PRIOR
CUTTING PRIOR
COMMAND
MENU
To Next Page
Loading...
