Roland XC-540 - Page 107

6-7 Correcting Misalignment for Printing or Cutting
105
Chapter 6 Feature Reference
-0.5
3. Print a test pattern and cut it.
➊
Press .
Press
.
➋
Press .
➌
Press .
Press
.
When adjustment is needed, go on to the steps below.
4. Print a test pattern and cut it.
Press .
Press
to execute.
5. From the test pattern, read the value at the location.
PRINT - CUT ADJ.
TEST PRINT 2
MENU
CUTTING MENU
CUTTING MENU
PRINT - CUT ADJ.
PRINT - CUT ADJ.
TEST PRINT

Printing position
Cutting position
Cutting position and print-
ing position are misaligned.
Cutting position and print-
ing position are aligned.
Printing position
Cutting position
+2.0 -2.0
-1.0
+0.5 -0.5
+0.0 -0.0
+1.5 -1.5
+2.0
-2.0
+1.0
-1.0
+0.5
-0.5
+0.0
-0.0
+1.5
-1.5
FEED
SCAN
Cutting line
Test pattern
Correction-value scale
Check the value on
the [SCAN] side.
Check the value on
the [FEED] side.
Scan direction
The point where the cutting line
intersects the correction-value
scale is the correction value. In this
figure, the value is "-0.3." Use the
same method to read the value on
the [FEED] side.
Cutting line