Roland XC-540 - Page 108

6-7 Correcting Misalignment for Printing or Cutting
106
Chapter 6 Feature Preference
6. Enter the correction value you read.
➊
Press .
➋
Press .
Use
to set the adjustment value for [FEED SETTING].
Use
to set the adjustment value for [SCAN SETTING].
Press
to enable the setting.
➌
Press .
7. Check the results of adjustment.
Press .
Press
to execute.
If the printing and cutting lines are aligned, adjustment is complete.
If further adjustment is needed, go back to step
6. and fine-tune the adjust-
ment.
Description
You perform this when printing followed immediately by cutting yields positioning for printing and cutting that is
slightly misaligned. You print alignment marks, perform detection of the printed marks, and correct the discrepancy.
Subtle misalignment between the printing and cutting positions may occur due to the thickness of the media or the
head height. We recommend making correction to match the media you're using.
Default Setting
[FEED SETTING]: 0.00 mm
[SCAN SETTING]: 0.00 mm
F :- 0.30 - 0.30mm
S : 0.00 - 0.20mm
PRINT - CUT ADJ.
SETTING
PRINT - CUT ADJ.
TEST PRINT

PRINT - CUT ADJ.
SETTING
Cutting position and print-
ing position are aligned.
Printing position
Cutting position