Roland XC-540 - Correcting Misalignment for Printing and Cutting When Using Crop Marks

6-7 Correcting Misalignment for Printing or Cutting
107
Chapter 6 Feature Reference
Correcting Misalignment for Printing and Cutting When Using Crop Marks
Procedure
1. Check the setting for the [AUTO ENV. MATCH] menu item.
Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
☞ P.84, "Making the Setting for Automatic Adjustment of the Printer to the Operating Environment"
2. Execute the [ADJUST BI-DIR] menu item.
➊
Load the media.
☞ P. 30, "How to Load Media"
☞ P. 90, "How to Load Sheet Media"
➋
Perform bidirectional adjustment.
☞ P. 100, "Correcting for Misalignment in Bidirectional Printing"
☞ P. 101, "Correcting for Misalignment in Bidirectional Printing More Precisely"
3. Print a test pattern and cut it.
➊
Press .
Press
.
➋
Press .
Press
.
➌
Press .
Press
.
When adjustment is needed, go on to the steps below.
4. Print a test pattern and cut it.
Press twice.
Press
to execute.
MENU
CUTTING MENU
CROP - CUT ADJ.
TEST PRINT
CUTTING MENU
CROP - CUT ADJ.
CROP - CUT ADJ.
TEST PRINT 2
Printing position
Cutting position
Cutting position and print-
ing position are misaligned.
Cutting position and print-
ing position are aligned.
Printing position
Cutting position