133
Chapter 7 What to Do If
The Media Jams
If an error message is displayed because the media
has jammed, immediately correct the problem. Fail-
ure to do so may damage the print heads.
☞ P. 139, [MOTOR ERROR TURN POWER OFF]
Is the media warped or wrinkled?
Many factors can cause warping or wrinkling. Refer to the
following and correct the problem.
☞ P. 135, "Media Wrinkles or Shrinks, or Feed Is Unstable"
Is the height of the print heads too low?
Try raising the heads higher. Media may inevitably warp or
wrinkle slightly, so adjust the height of the heads to take
this into account.
☞ P. 85, "Adjusting Head Height to Match Media Thick-
ness"
7-3 The Media Jams
To Next Page
Loading...
