Roland XC-540 - 8-5 Product Specifications

146
Chapter 8 Appendix
8-3 About the Blade
The cutting conditions and the service life of the blade change according to the media and the operating environment,
even when using identical blades. The service life also differs according to the type of blade. A rough guide is shown
below.
When uncut areas remain even when the blade force is increased to a value that is higher by 50 to 60 gf than the
values shown in this chart, then replace the blade.
*The values for "Blade life" are estimates for when cutting media of identical type.
Blade
ZEC-U1005
ZEC-U5025
Media
General signage vinyl
General signage vinyl
Fluorescent vinyl
Reflective vinyl
Blade force
50 to 150 gf
30 to 100 gf
120 to 200 gf
100 to 200 gf
Amount of blade offset
0.25 mm
0.25 mm
0.25 mm
0.25 mm
Blade life*
(general guide)
8,000 m
4,000 m
4,000 m
4,000 m