Roland XC-540 - 3-2 Printing Followed by Immediate Cutting

46
Chapter 3 Using the Cutting Feature
3-1 Performing Cutting
To Perform Cutting
To perform cutting, carry out the procedure described below.
CAUTION
Be sure to carry out the operation according to the procedure described.
Otherwise a motor error may occur or the roll may fall because the media is pulled with
excessive force.
Procedure
➊
Detach the media clamps.
➋
When you're performing cutting only,
then if you're cutting roll media, allow
the media to hang down from the rear
of the machine.
Important Notes on Cutting
➢Never use the media clamps. Using them may cause malfunction.
➢If you're using the [PREFEED] feature, the media is automatically fed out and taken up again before cutting is
performed. This makes it unnecessary to run out media to the rear of the machine before the operation.
☞ P.93, "Preventing Pulling of the Media with Undue Force When Performing Cutting Only"
➢When you're performing cutting, move the dancer roller toward the rear, or detach it. Otherwise media pulled
out to the front during lengthy output may interfere with the dancer roller, which may affect output quality.
Turn the media flanges by hand to pull out the
necessary length from the roll.
Media clampMedia clamp