Roland XP-60 - 鍵盤分解手順

XP-60 Apr. 1998
12
KEYBOARD DISASSEMBLY
1. ATTACHING THE PCBs
1) First, turn the chassis over on the other side, being careful
not to reverse the right and left ends.
Next, as shown in fig. 1, place SPACER 12P (4 pieces)
on the chassis from the left end (the bass side of
keyboard), aligning them with the posisioning holes
provided on the chassis.
(Refer to fig. 2.)
In the same way, place SPACER 13P on the right side of
the chassis (the treble side).
PARTS No,
PARTS NAME
Qty.
70890767
70890778
01015134
01015145
22205597
22205598
SK-8A61 PWB HI-AFT ASSY
SK-8A61 PWB LOW ASSY
SK-8A RUBBER SWITCH 12P
SK-8A RUBBER SWITCH 13P
SK-8 PCB SPACER 12P
SK-8 PCB SPACER 13P
BINDING TAPTIGHT B 3x10mm ZC
1
1
4
1
4
1
2440012256
fig.1
fig.2
Bass Side
Treable Side
Positioning Hole of Chassis
Positioning Holes of Chassis
SPACER 12P x4
SPACER 13P
Positioning Holes of Chassis
Required Parts
/鍵盤分解手順
1. 基板の取り付け方
1) まず、シャーシを左右が逆にならないように裏返し
ます。
次に、fig. 1に示すように左側（鍵の低音側）より、
SPACER 12Pを4個、シャーシの位置決め穴に合わせ
て順に置いていきます。
（fig. 2参照のこと）
右側（高音側）にはSPACER 13Pを同様に置いてい
きます。
/必要部品