128
<Procedure>
❶ Make sure that the Track Edit Menu display
(SEQ/TrkEdit) is up.
❷ Press [F6] (Menu) to select Menu 2, then press [F1]
(Chg Vel) to call up the Change Velocity display
(SEQ/TrkEdit).
This display can also be called up by moving the cursor to “6
Chg Velocity” and pressing [ENTER] on the Track Edit
Menu display (SEQ/TrkEdit). Or press the numeric key [6],
then [ENTER].
❸ Move the cursor to Target track and select the Phrase
track(s) or Pattern whose velocity you want to modify.
❹ When assigning editing area by measures, move the
cursor to “Measure” and specify the measure number
at which velocity change is to begin, then move the
cursor to “for” to specify the measure length over
which velocity will change.
When using Locate positions, press [LOCATE], and move
the cursor to “From” to select the Locate number at which
you want velocity to start changing. Move the cursor to “to”
and select the Locate number at which you want velocity
change to end.
❺ Move the cursor to “Bias” and set the amount of veloc-
ity addition.
❻ Move the cursor to “Magnify” and set the ratio of
velocity variation.
❼ Move the cursor to “Channel” and select the MIDI
channel(s) of notes for which velocity will be modified.
❽ Move the cursor to “Note Range” and set the note
number range over which velocity will be modified.
You can also set this parameter through key input on the
keyboard.
❾ Press [F6] (Execute) to begin velocity change.
Changing MIDI channel – 7 Chg Channel
(Change MIDI channel)
This function transfers the MIDI channel of a specified area
of sequencer data into a different MIDI channel.
Target track
Selects the Phrase track(s) or Pattern in which you want to
reassign the MIDI channel of the data.
TRK ALL: Phrase tracks 1–16
TRK 1–TRK 16: The specified Phrase track
PTN 001–PTN 100: The specified Pattern
Measure (From), for (to) (Editing area)
Specifies the area of measures for which the MIDI channel
will be changed.
Status
Selects the type of data for which you wish to change the
MIDI channel.
ALL: All types of sequencer data
NOTE: Note
P.AFT: Polyphonic Aftertouch
C.C: Controller numbers
PROG: Program numbers
C.AFT: Channel Aftertouch
BEND: Pitch Bend
Range
If you have selected NOTE, P.AFT, C.C or PROG for the
Status parameter, use this parameter to set the area.
To change all MIDI channels of Note or Polyphonic
Aftertouch data, specify “C-1–G9.” To change the MIDI
channel of C4 Note/Polyphonic Aftertouch data, specify
“C4–C4.” To change the MIDI channels of Note/Polyphonic
Aftertouch data of a C3 to C4 range, specify “C3–C4.”
To change the MIDI channels of all Controller numbers or
Program numbers, set “0–127.” To change the MIDI channel
of number 4, set “4–4.” To change the MIDI channels of
numbers 3 to 14, set this parameter to “3–14.”
Channel (MIDI channel)
Set the source MIDI channel at the left section of this para-
meter and destination MIDI channel at the right section.
If you have selected ALL for the source MIDI channel, the
sequencer data of all MIDI channels will be combined into
the destination MIDI channel.
To Next Page
Loading...
