Deleting blank measures – 15 Truncate
Copying or merging may sometimes create blank measures
at the beginning of a Phrase track or Pattern. Truncate
deletes the ‘silent’ portion from the beginning of a specified
Phrase track or Pattern until the first note-on.
✳ If Program Change, Control Change, or other data
except Note is contained in the section from the begin-
ning of the specified Phrase track or Pattern until the
first note-on, only the last event of each data type will
be put before the note-on.
Target track
Selects the track or Pattern from which blank measures are
to be truncated.
TRK 1–TRK 16: The specified Phrase track
PTN 001–PTN 100: The specified Pattern
From, to (Deleting area)
The display will show the beginning position of the Phrase
track or Pattern specified by the Target track parameter
(From) and the position of the first note-on (to).
<Procedure>
❶ Make sure that the Track Edit Menu display (SEQ/
TrkEdit) is up.
❷ Press [F6] (Menu) to select Menu 3, then press [F5]
(Truncate) to call up the Truncate leading Blank dis-
play (SEQ/TrkEdit).
You can also call up this display by moving the cursor to “15
Truncate” and pressing [ENTER] on the Track Edit Menu
display (SEQ/TrkEdit). Or press the numeric keys [1] and
[5], then [ENTER].
❸ Select the Phrase track or Pattern that is to be truncat-
ed.
❹ The area to be deleted will be displayed in “From” and
“to.”
✳ A short search time may be required to locate the silent
section in the specified Phrase track or Pattern.
❺ Press [F6] (Execute) to truncate.
To Next Page
Loading...
