Roland XP-80 - Page 201

20: QUADRUPLE-TAP-DELAY (P.81)
Parameter Name Full Name of Parameter Value
Delay 1 Delay time1 200—1000ms,note
Delay 2 Delay time2 200—1000ms,note
Delay 3 Delay time3 200—1000ms,note
Delay 4 Delay time4 200—1000ms,note
Level 1 Level1 0—127
Level 2 Level2 0—127
Level 3 Level3 0—127
Level 4 Level4 0—127
Feedback Feedback level -98—+98%
HF Damp HF damp 1*
Balance Effect balance D100:0E—D0:100E
Level Output level 0—127
1*: 200, 250, 315, 400, 500, 630, 800,1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000Hz, BYPASS
21: TIME-CONTROL-DELAY (P.82)
Parameter Name Full Name of Parameter Value
Delay Delay time 200—1000ms
Acceleration Acceleration 0—15
Feedback Feedback level -98—+98%
HF Damp HF damp 1*
Pan Output pan L64—0—63R
Low Gain Low gain -15—+15 dB
High Gain High gain -15—+15 dB
Balance Effect balance D100:0E—D0:100E
Level Output level 0—127
1*: 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000Hz, BYPASS
22: 2VOICE-PITCH-SHIFTER (P.82)
Parameter Name Full Name of Parameter Value
Coarse A Coarse pitch A -24—12 semitone
Fine A Fine pitch A -100 -100 cent
Pan A Output pan A L64—0—63R
Pre Delay A Pre delay time A 0.0—500 ms
Coarse B Coarse pitch B -24—12 semitone
Fine B Fine pitch B -100 -100 cent
Pan B Output pan B L64—0—63R
Pre Delay B Pre delay time B 0.0—500 ms
Mode Pitch shifter mode 1,2,3,4,5
Level Balance Level balance A100:0B—A0:100B
Balance Effect balance D100:0E—D0:100E
Level Output level 0—127
23: FBK-PITCH-SHIFTER (P.83)
Parameter Name Full Name of Parameter Value
Coarse Coarse pitch -24—12 semitone
Fine Fine pitch -100 -100 cent
Pan Output pan L64—0—63R
Pre Delay Pre delay time 0.0—500 ms
Mode Pitch shifter mode 1,2,3,4,5
Feedback Feedback level -98—+98%
Low Gain Low gain -15—+15 dB
High Gain High gain -15—+15 dB
Balance Effect balance D100:0E—D0:100E
Level Output level 0—127
24: REVERB (P.83)
Parameter Name Full Name of Parameter Value
Type Reverb type ROOM1,ROOM2,STAGE1,
STAGE2,HALL1,HALL2
Pre Delay Pre delay time 0.0—100 ms
Time Reverb time 0—127
HF Damp HF damp 1*
Low Gain Low gain -15—+15 dB
High Gain High gain -15—+15 dB
Balance Effect balance D100:0E—D0:100E
Level Output level 0—127
1*: 200,250,315,400,500,630,800,1000,1250,1600,2000,2500,3150,4000,
5000,6300,8000Hz,BYPASS
25: GATE-REVERB (P.84)
Parameter Name Full Name of Parameter Value
Type Gate reverb type NORMAL,REVERSE,
SWEEP1,SWEEP2
Pre Delay Pre delay time 0.0—100ms
Gate Time Gate time 5—500ms
Low Gain Low gain -15—+15 dB
High Gain High gain -15—+15 dB
Balance Effect balance D100:0E—D0:100E
Level Output level 0—127
26: OVERDRIVE ➞ CHORUS (P.84)
Parameter Name Full Name of Parameter Value
OD Drive Drive 0—127
OD Pan Output pan L64—0—63R
Chorus Pre Delay Chorus pre delay time 0.0—100ms
Chorus Rate Chorus rate 0.05—10.0Hz
Chorus Depth Chorus depth 0—127
Chorus Balance Chorus balance D100:0E—D0:100E
Level Output level 0—127
27: OVERDRIVE ➞ FLANGER (P.84)
Parameter Name Full Name of Parameter Value
OD Drive Drive 0—127
OD Pan Output pan L64—0—63R
Flanger Pre Delay Flanger Pre delay time 0.0—100ms
Flanger Rate Flanger rate 0.05—10.0Hz
Flanger Depth Flanger depth 0—127
Flanger Feedback Flanger feedback level -98—+98%
Flanger Balance Flanger balance D100:0E—D0:100E
Level Output level 0—127
28: OVERDRIVE ➞ DELAY (P.85)
Parameter Name Full Name of Parameter Value
OD Drive Drive 0—127
OD Pan Output pan L64—0—63R
Delay Time Delay time 0.0—500ms
Delay Feedback Delay feedback level -98—+98%
Delay HF Damp Delay HF damp 1*
Delay Balance Delay balance D100:0E—D0:100E
Level Output level 0—127
1*: 200,250,315,400,500,630,800,1000,1250,1600,2000,2500,3150,4000,
5000,6300,8000Hz,BYPASS
201
Chapter 12. Supplementary material