4
Part of
Practice
Fully Utilizing Cutting Function
121
Fine-tuning the Cutting Conditions
Procedure
Performing the Cutting Test
P. 66, "Setting The Cutting Test And The Blade Force" Procedure
1.
When cutting of the test patterns is completed, press .
Press to select the cutting condition
you want to set.
For information on the evaluation method of cutting test, refer to the next page.
[Force]
This sets the force (pressure) of the blade. (Default Setting 50gf )
[Speed]
This sets the speed of cutting. Default Setting: 30 cm/s)
[OFFSET]
This makes the blade-oset setting for the blade. Enter the listed oset value for the blade. (Default
Setting: 0.250 mm)
[UP-SPEED]
This sets the blade's up speed during cutting (the speed at which the blade travels when it moves to the
next cutting line after cutting one cutting line). If the media comes loose during no-load feed and the
blade damages the surface of the media, reduce the speed. (Default Setting: 30 cm/s)
Press to select a value.
Press
to enable the setting.
To Next Page
Loading...
