4
Part of
Practice
Fully Utilizing Cutting Function
127
Description
You perform this when printing followed immediately by cutting yields positioning for printing and cutting
that is slightly misaligned. You print alignment marks, perform detection of the printed marks, and correct the
discrepancy. Subtle misalignment between the printing and cutting positions may occur due to the thickness
of the media or the head height. We recommend making correction to match the media you're using.
Default Setting
[F] (correction value of media feed direction): 0.00mm
[S] (correction value of head movement direction): 0.00mm
Prioritize The Cuttings Settings of This Machine to The Settings of a Computer Side in Software RIP
Procedure
Hold down and press .
Press twice to display the left gure.
Press
.
Press to select “MENU.”
Press
to enable the setting.
Press in this order to go back to the original screen.
Description
You can also make the settings for the cutting conditions using the software RIP. By default, the settings made
with the software RIP take priority. To make the cutting conditions set on the machine take priority, either turn
o the settings of the software RIP or make the setting described above.
Default Setting
[CUTTING PRIOR]: COMMAND
To Next Page
Loading...
