Roland XR-640 - Print Heads Stop Moving. Why; What to Do First; If the Print Heads Still Do Not Move

171
6
FAQ
Print Heads Stop Moving. Why?
If the print-head carriage stops over the platen, take action immediately to prevent the heads
from drying out.
What to Do First
Switch the sub power off, then back on
again.
If the media is jammed, then also remove
the media.
If the print-head carriage move to the stand-
by position (inside the cover R), it means
the operation has ended successfully.
If The Print Heads Still Do Not Move
Try switching o the main power, then again switching on the main power, followed by the sub power.
If the Print Heads Still Do Not Move
If the print heads still do not move, carry out the following emergency response measure, then contact your
authorized Roland DG Corp. dealer.
Procedure

Switch off the main power and open the front cover.

Remove the Cover R.
Remove the screws, lift the cover R in the direction of
and then pull it out in the direction of .

Gently move the print head carriage to the
standby position.
Stopping at the place where the audible click is heard
locks the print heads in place.
Screws