Roland XR-640 - Page 43

Loading Media
2
Basic Operation
41

Hold the outer side of the media holder [Left] and position the left and right side edges
of the media to match the grit patterns.
When deciding the position, hold the both sides of media holders from the outer sides and move it. Do
not hold the media directly to move.
CAUTION
Never attempt this operation while holding any location other than the
one specied.
The media may fall from the media holder, resulting in injury.

Secure the media holder by tightening the securing screws slightly.
The retaining screw may get damaged if tightened excessively.
Decide the left and right side positions of the media nally at this step.
After this procedure is completed, if the left and right side positions do not t the proper position
when securing the media with pinch rollers, go back to this step to redo this procedure. Printing
quality is aected due to skew media feed, if you hold the media only to readjust the position forcibly.
Grit mark
The grit marks indicate the
positions of the grit rollers.
Set the media within the grit
marks.