Roland XR-640 - Performing the Initial Adjustment (Correcting for Misalignment in Bidirectional Printing More Precisely)

2
Basic Operation
Loading Media
47
Loading the Sheet Media
Procedure

Move the media holders to the left and right.
Move them to a location where they don’t disturb the media when the media is hung down from the
rear of the machine. If they disturb the media, remove them with the shaft. For information on how to
remove, refer to “Setup Guide.”

Pass the media through the printer and secure the media holders.
 P. 39, "Loading Roll Media"Procedure 2.

to

of [Loading Roll Media]

Align the front edge of the media with the location shown in the gure.
Loosen. Loosen.
Align here.