Roland XR-640 - Page 60

2
Setup of Media
Basic Operation
58

Use to set the correction value of FEED
side (F).
Use
to set the correction value of scan
direction (S).
Press
to enable the setting.
The test pattern (P&C1) is printed and cut again. Check the condition
of test pattern to check that the printing position and the cutting
position are aligned.

[Cutting position and printing position are aligned]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure 9.
[Cutting position and printing position are not aligned]
Press
to select [YES].
Press
to enable the setting.
Go back to Procedure

, ne-tune the adjustment value, and then
repeat Procedure

and

until the optimal alignment is got.
For the individual setting method of this setting item and the description, refer to  P. 134, "Correcting
Misalignment for Printing and Cutting Position When Using Crop Marks"
9. Correcting Misalignment for Printing and Cutting Position When Using Crop Marks.

[To perform consecutive printing and cutting]
Press
to select [NEXT].
Go to Procedure
10.
[To perform printing and cutting separately]
Press
to select [SET].
Press
to enable the setting.
The test pattern (C&C1) is printed and cut. Go to Procedure

.
F :- 0.30 - 0.30mm
S : 0.00 - 0.20mm
REDO ADJ.?
YES [DONE]
When you remove the printed media, and then reload it and perform cutting, use the crop marks.
For this case, correction is to be performed because the positioning of printing and cutting may be
misaligned even when you're using crop marks depending on the composition of the media.
CROP-CUT ADJ.
[SET] NEXT
Current correction
value
Value to be set