2
Basic
Operation
62
Outputting
Setting the Output-start Location
You can set the output-start location at any location you prefer. (You can output if you do not set this.) Note,
however, that this setting must be made for each individual page.
Procedure
Open the front cover.
Use to move the center of the blade with the output-
start location.
Only cutting carriage moves.
When the location is set, press .
remains steadily lighted and when the screen displays the char-
acter “B” together with the output-possible width at the location, setting
is completed.
W1100mm
B
Note, however, that the left and right positions are not restored to their defaults for test patterns.
If you’re using the media take-up unit, never adjust by pressing
. Doing so may pull the
media with undue force, resulting in an error or malfunction.
Start location
To Next Page
Loading...
