Roland XR-640 - Chapter 3 Maintenance: For always using the printer in the best condition

2
Basic Operation
71
Switch Off
Switch Off
WARNING
When output is not being performed, remove any loaded media or switch
off the sub power.
The continued application of heat at a single location may cause the release
of toxic gases from the media or pose a re hazard.
Procedure

Hold down the sub power button for one
second or longer.
The sub power is turned o. Perform this process
after output is nished.

Press back the loading lever.
Press back the loading lever when the machine is not
used even if the power is not turned o.
Leave the main power switched on at all times.
Never switch o the main power. By switching on the main power, the automatic maintenance function
is carried out periodically. If the automatic maintenance is not carried out, it may result in breakdown
of this machine such as breakdown of the print heads.
Never switch off the main power or unplug the power cord suddenly while operation
is in progress.
Switching o the main power or unplugging the power cord suddenly while operation in progress
may damage the print heads. Be sure to rst switch o the sub power.
If the main power is accidentally switched o, immediately turn the power back on.