EasyManua.ls Logo

Roland XV-2020 - 1: STEREO EQ; 2: OVERDRIVE; 3: DISTORTION

Roland XV-2020
169 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
82
Using the XV-2020 Effects
Multi-Effects Parameters
The multi-effects feature 90 different kinds of effects. Some of the
effects consist of two or more different effects connected in series or
in parallel.
Parameters marked with a sharp “#” can be simultaneously
controlled using the selected controller.
1: STEREO EQ (p. 82)
2: OVERDRIVE (p. 82)
3: DISTORTION (p. 82)
4: PHASER (p. 83)
5: SPECTRUM (p. 83)
6: ENHANCER (p. 83)
7: AUTO WAH (p. 83)
8: ROTARY (p. 83)
9: COMPRESSOR (p. 84)
10: LIMITER (p. 84)
11: HEXA-CHORUS (p. 84)
12: TREMOLO CHORUS (p. 84)
13: SPACE-D (p. 85)
14: STEREO CHORUS (p. 85)
15: STEREO FLANGER (p. 85)
16: STEP FLANGER (p. 85)
17: STEREO DELAY (p. 86)
18: MODULATION DELAY (p. 86)
19: TRIPLE TAP DELAY (p. 87)
20: QUADRUPLE TAP DELAY (p. 87)
21: TIME CONTROL DELAY (p. 87)
22: 2 VOICE PITCH SHIFTER (p. 87)
23: FB PITCH SHIFTER (p. 88)
24: REVERB (p. 88)
25: GATED REVERB (p. 88)
26: OVERDRIVE -> CHORUS (p. 88)
27: OVERDRIVE -> FLANGER (p. 89)
28: OVERDRIVE -> DELAY (p. 89)
29: DISTORTION -> CHORUS (p. 89)
30: DISTORTION -> FLANGER (p. 89)
31: DISTORTION -> DELAY (p. 89)
32: ENHANCER -> CHORUS (p. 89)
33: ENHANCER -> FLANGER (p. 90)
34: ENHANCER -> DELAY (p. 90)
35: CHORUS -> DELAY (p. 90)
36: FLANGER -> DELAY (p. 90)
37: CHORUS -> FLANGER (p. 91)
38: CHORUS/DELAY (p. 91)
39: FLANGER/DELAY (p. 91)
40: CHORUS/FLANGER (p. 91)
1: STEREO EQ (Stereo Equalizer)
This is a four-band stereo equalizer (low, mid x 2, high).
fig.02-001m
2: OVERDRIVE
Creates a soft distortion similar to that produced by vacuum tube
amplifiers.
fig.02-002m
3: DISTORTION
Produces a more intense distortion than Overdrive. The parameters
are the same as for “2: OVERDRIVE.”
fig.02-003m
Parameter Value Description
Low Freq 200, 400 Hz Frequency of the low range
Low Gain -15-+15 dB Gain of the low frequency range
Mid1 Freq 200-8000 Hz Frequency of Middle Range 1
Mid1 Gain -15-+15 dB Gain of Middle Range 1
Mid1 Q 0.5, 1.0, 2.0, 4.0,
8.0
Width of Middle Range 1
Select a higher Q value to narrow
Middle Range 1.
Mid2 Freq 200-8000 Hz Frequency of Middle Range 2
Mid2 Gain -15-+15 dB Gain of Middle Range 2
Mid2 Q 0.5, 1.0, 2.0, 4.0,
8.0
Width of Middle Range 2
Select a higher Q value to narrow
Middle Range 2.
High Freq 2000, 4000, 8000
Hz
Frequency of the high range
High Gain -15-+15 dB Gain of the high frequency range
Level # 0-127 Output level
Parameter Value Description
Drive # 0-127 Amount of distortion
Also changes the volume.
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double-stack amp
3-STACK: large triple-stack amp
Low Gain -15-+15 dB Gain of the low frequency range
High Gain -15-+15 dB Gain of the high frequency range
Level 0-127 Output level
Pan # L64-63R Stereo location of the OVERDRIVE
output
L in
R in
L out
R out
4-Band EQ
4-Band EQ
Amp
Simulator
2-Band
EQ
L in
R in
Over
drive
L out
R out
Pan R
Pan L
L in
R in
L out
R out
Pan R
Pan L
Amp
Simulator
2-Band
EQ
Distortion

Table of Contents

Related product manuals