55
Chapter 2. Creating a Rhythm Set
Chapter 2
Settings Common to an Entire Rhythm Set
Setting Procedure:
1.
Hold down [SHIFT] and press [PATCH] to make its indicator blink.
The XV-5050 enters Rhythm Set mode.
2.
Choose the Rhythm Set you wish to use.
3.
Press [EDIT] to make its indicator light.
4.
Press [ CURSOR] a few times to move the cursor to the parameter group at the upper line of the display.
fig.2-03.e
5.
Turn [VALUE] to choose "COMMON."
6.
Press [CURSOR ] to move the cursor to the parameter.
7.
Turn [VALUE] to choose the parameter you want to set.
8.
Press [CURSOR ] to move the cursor to the value.
9.
Turn [VALUE] to choose the desired value.
10.
Press [EXIT] to return to the RHYTHM PLAY screen.
A “*” symbol appears at the left of the Rhythm Set name, indicating that its settings have been changed.
fig.2-04
If you turn off the power or choose another Rhythm Set while the "*" symbol is displayed, your new Rhythm Set settings will be lost. If you
wish to preserve them, save the changed Rhythm Set using the Write operation. (p. 104)
Parameter
Value Description
COMMON
Name
Rhythm set name space, A–Z, a–z, 0–9, ! " # $ % & ’ ( ) *
+ , - . / : ; < = > ? @ [ ¥ ] ^ _ ` {
| }
You can name a Rhythm Set using up to 12 alphanumeric characters. Use
[ CURSOR]/[CURSOR ] to move the cursor, and then turn the [VALUE]
knob to select the desired character.
Level Rhythm set level 0–127 This sets the overall volume of the Rhythm Set.
* To set the volume of each Rhythm Tone, use the Tone Level (TVA p. 61).
Output Asgn Rhythm output
assign
MFX, OUTPUT A/B, INDIV 1–4,
TONE
This sets the output destination of the Rhythm Set.
MFX:
The Rhythm Set is sent into the Multi-Effects.
OUTPUT A/B:
The Rhythm Set is sent to the selected pair of OUTPUTs, A or B.
INDIV 1–4:
The Rhythm Set is sent to the selected INDIVIDUAL output jack, 1-4.
TONE:
Each Rhythm Tone in the Rhythm Set is sent to its programmed output
destination.
Clock Source Rhythm set clock
source
RHYTHM, SYSTEM The LFO cycle, M-FX changes, phrase loop (break beats), and Tone delay time can
be synchronized to a clock, or tempo. The Clock Source setting selects the timing
reference to be used by the Rhythm Set.
RHYTHM:
The Rhythm Set Tempo will be used.
SYSTEM:
The global System Tempo or clock messages received from an exter-
nal sequencer will be used.
Tempo Rhythm set tempo 20–250 When Clock Source is set to “RHYTHM,” this setting establishes the Rhythm Set’s
tempo.
* Clock messages for the Rhythm Tempo are not transmitted from the MIDI OUT
jack.
ValueParameter
Parameter Group
XV-5050_e.book 55 ページ ２００３年６月２７日 金曜日 午後３時１４分
To Next Page
Loading...