5
Getting Ready to Play
5
Slots are provided inside the XV-5080 for SRX Series and SR-
JV80 Series boards. Referring to the diagram below, plug the
wave expansion board’s connector into the connector at the
wave expansion board slot, and simultaneously insert the
board holder into the hole in the Wave expansion board.
fig.00-004.e(Install)
6
Use the Installation Tool supplied with the Wave Expansion
Board to turn the holders in the LOCK direction, so the board
will be fastened in place.
fig.00-005.e(lock)
7
Use the screws that you removed in step 2 to fasten the cover
back in place.
This completes the installation of the wave expansion board.
Holder
Conecter
SRX Series SR-JV80 Series
LOCK
To Next Page
Loading...
