237
Error Messages
Appendices
Memory Card Write Protected
Situation: Since a write protect sticker is affixed to the
memory card, data cannot be saved to the card
bank.
Action: Remove the write protect sticker from the
memory card.
Memory Error!
Cause: For some reason, wave memory cannot be read
or written.
Action: The SIMM may be damaged. If the same message
appears even after reinstallation, use a different
SIMM.
Memory Full!
Cause: Due to insufficient wave memory, Reading is not
possible.
Action: Delete unwanted samples from the XV-5080’s
memory (p. 197).
MIDI Buffer Full
Situation: Due to an inordinate volume of MIDI messages
received, the XV-5080 has failed to process them
properly.
Action: Reduce the amount of MIDI messages to be
transmitted.
MIDI Communication Error
Situation: A problem has occurred with the MIDI cable
connections.
Action: Check that MIDI cables are not broken or pulled
out.
Number ‘****’ Will Be Deleted. Are
You Sure?
Condition: The sample at internal sample number ‘****’ will
be deleted. Is it OK to execute?
Action: To cancel the operation, press [F1 (CANCEL)].
To execute the deletion, press [F6 (DELETE)].
PASSWORD PROTECTED, This Zip Disk
is Protected by Password!
Situation: This disk is write-protected by password. The
write protection cannot be removed with the
XV-5080.
Action: Either use the device with which the password
protection was applied to remove the
protection, or prepare a Zip disk that is not
write-protected.
Path Duplicate!
Cause: You are attempting to write to the same
hierarchical level.
Action: Change the writing destination.
Path Name Too Long!
Cause: The path name is too long.
Action: Shorten the names of each folder. Alternatively,
move the entire folder to a shallower level of the
hierarchy (p. 201).
* The “path” indicates the hierarchical level at which the file is
located. It is given together with the folder name.
Performance (Patch/Partial/Sample)
Full!
Situation: Although the specified data was loaded, the
required free space for the Performance (Patch/
Partial/Sample) is not available.
Action: Try loading again after deleting any unneeded
Performances (Patches/Partials/Samples).
Receive Data Error
Situation: A MIDI message was received incorrectly.
Action: If the same error message is displayed
repeatedly, there is a problem with the MIDI
messages that are being transmitted to the XV-
5080.
To Next Page
Loading...
