Roland XV-5080. - Page 274

274
Parameter List
85:CLEAN GUITAR MULTI B(p. 101)
Parameter Value
Sequence
Wah Wah Switch OFF, ON
3 Band EQ 3 Band EQ Switch OFF, ON
Delay Delay Switch OFF, ON
Cho/Flg Chorus/Flanger Switch OFF, ON
Wah
Filter type Filter type LPF, BPF
Rate Rate 0.05-10.00 Hz, note *2
Depth Depth 0-127
Sens Sens 0-127
Manual Manual 0-127
Peak Peak 0-127
EQ Gain
Low Low gain -15 – +15 dB
Mid Mid gain -15 – +15 dB
High High gain -15 – +15 dB
Mid
Mid Freq Mid Freq (*1)
Mid Q Mid Q 0.5, 1.0, 2.0, 4.0, 8.0
Delay
Left Time Left Time 0 - 3000 [ms], note *2
Right Time Right Time 0 - 3000 [ms], note *2
Feedback Feedback -98 - +98 [%]
HF Damp HF Damp (*2)
Balance Balance D100:0W - D0:100W
Chorus/Flanger
Select Select CHORUS,FLANGER
Pre Delay Pre Delay 0.0 - 100 [ms]
Rate Rate 0.05 - 10.0 [Hz], note *2
Depth Depth 0 - 127
Feedback Feedback -98 - +98 [%]
Balance Balance D100:0E - D0:100E
Filter
Type Type OFF, LPF, HPF
Cutoff Cutoff Frequency (*1)
Output
Level Level 0 - 127
Pan Pan L64 - 63R
*1: 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000 [Hz]
*2: 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000, BYPASS
86:BASS MULTI(p. 102)
Parameter Value
Sequence
Comp Compressor Switch OFF, ON
OD/Dist Overdrive/Distortion Switch OFF, ON
Amp Sim Amp Simulator Switch OFF, ON
3 Band EQ 3 Band EQSwitch OFF, ON
Cho/Flg Chorus/Flanger Switch OFF, ON
Compressor
Attack Attack 0 - 127
Sustain Sustain 0 - 127
Level Level 0 - 127
Overdrive/Distortion
Type Type OVERDRIVE, DISTORTION
Drive Drive 0 - 127
Tone Tone 0 - 127
Level Level 0 - 127
Amp Simulator
Type Type SMALL, BUILT-IN, 2-STACK
EQ Gain
Low Low gain -15 – +15 dB
Mid Mid gain -15 – +15 dB
High High gain -15 – +15 dB
Mid
Mid Freq Mid Freq (*1)
Mid Q Mid Q 0.5, 1.0, 2.0, 4.0, 8.0
Chorus/Flanger
Type Type CHORUS,FLANGER
Rate Rate 0.05 - 10.0 [Hz], note *2
Depth Depth 0 - 127
Feedback Feedback -98 - +98 [%]
Pre Delay Pre Delay 0.0 - 100 [ms]
Balance Balance D100:0W - D0:100W
Filter
Type Type OFF, LPF, HPF
Cutoff Cutoff Frequency (*1)
Output
Level Level 0 - 127
Pan Pan L64 - 63R
*1: 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000 [Hz]
87:ISOLATOR 2(p. 104)
Parameter Value
Boost/Cut
Low Level low -60 – +4 dB
Mid Level middle -60 – +4 dB
High Level high -60 – +4 dB
Anti Phase Low
Switch Switch OFF, ON
Level Level 0 – 127
Anti Phase Mid
Switch Switch OFF, ON
Level Level 0 – 127
Post Filter
Switch Switch OFF, ON
Type Filter type OFF, LPF, HPF
Cutoff Cutoff frequency 0-127
Resonance Resonance 0-127
Slope Slope -12, -24 dB
Gain Gain 0-24 dB
Low Boost
Switch Switch OFF, ON
Level Level 0 – 127
Output
Level Output level 0 – 127