25
- Home: By default, only your entry sensors are included in this state. You can move about your
house freely. This is commonly used at bedtime, and as a default does not arm your motion
sensor.
• Alert Mode Settings
- In the app, you have the option to change the alert mode settings for entry and motion sensors.
• Panic Button on Keypad
- To initiate a panic alarm from your keypad: In an emergency situation, push the Cancel, (“X”) and
the Enter, (“OK”) buttons at the same time to initiate a panic alarm signal which will immediately
trigger police dispatch.
Note: To verify the current state of your system, you can either look at your app or tap any button on
the Keypad. This will trigger the illumination of one of the three buttons on the right side of your
Keypad (Armed – Home, Armed – Away, or Disarmed).
How to Use Your Security360 System
Security Modes
• Disarmed
- Off: Indicates your system is “off” and your system is not armed. Typically, you will be in the
disarmed state when you are home during the day.
• Armed
- Away: By default, your entry and motion sensors are included in this state. This is the typical
mode to set when no one is home.
To Next Page
Loading...