6
Connect
•
Connect the power cord to SmartBase and then plug it into a wall power outlet. Make sure that
this is not a switched outlet. You will hear a confirming audio message (“I am connected”) and will
receive a notification on your smartphone. Pull the red tab from the battery door.
• Ensure that the SmartBase is in “Pairing mode” and the light ring is blinking green. If it is not,
push the gray button on the back of the SmartBase until the light ring starts blinking green. It will
remain in this connecting state for 10 minutes – plenty of time to connect the sensors one at a
time.
Placement
The SmartBase should be located in a central place in your home like the kitchen, entryway, office or
living room area. This will allow you to see visual cues and hear audible sounds and phrases from
the SmartBase when alarms are triggered and during the arming/disarming process.
Name Your SmartBase
Your SmartBase should appear in the app with a default name. If you would like to change this
name, go to the app and tap on the SmartBase tile and select “Change Name.” Then create a
custom name for your SmartBase and tap “Save.”
To Next Page
Loading...