Rosen Entertainment Systems Copyright 2006 all rights reserved
AV7000 Installation Guide 9100685-91 Rev B
Page 1
INSTALLATION GUIDE
AV7000 Dual DVD Headrest Replacement System
NOTICE OF INTENDED INSTALLATION AND USE E
ROSEN ENTERTAINMENT SYSTEMS VIDEO PRODUCTS ARE NOT INTENDED FOR VIEWING BY
THE DRIVER, AND ARE TO BE INSTALLED ONLY TO BE VIEWED BY REAR-SEAT OCCUPANTS.
IMPROPER INSTALLATION COULD DISTRACT THE DRIVER OR INTERFERE WITH SAFE
OPERATION OF THE VEHICLE, WHICH COULD RESULT IN SERIOUS INJURY OR DEATH, AND
COULD ALSO VIOLATE STATE LAW. ROSEN ENTERTAINMENT SYSTEMS DISCLAIMS ANY
LIABILITY FOR ANY BODILY INJURY OR PROPERTY DAMAGE THAT MAY RESULT FROM ANY
IMPROPER OR UNINTENDED INSTALLATION AND/OR USE.
BEFORE YOU START THE INSTALLATION, READ THIS GUIDE!
Rosen “Headrest DVD” systems are the easiest-to-install DVD entertainment systems available today.
However, we strongly recommend reading this guide before starting the installation!
For additional technical tips, please see
www.rosendealercentral.com
1 Make sure you have the tools you will need
These common items are needed to complete this installation:
· Digital multimeter (DMM) · #2 Phillips screwdriver
·
Appropriate tool for headrest removal
·
Allen wrench set
·
Panel removing tools
·
Cable routing tool (included)
·
Security latch tool (included)
·
Retractable knife
·
Wire cutters, strippers, and a crimping tool
·
1/4” drive sockets are often needed for dashboard and trim disassembly
·
Check if Torx or Allen-drive bolts are used on any panels you will be removing
·
You will need a DVD
in good condition
when testing the system
Standard installation parts you will need include wire, wire ties, wire crimp connectors or solder, and
electrical insulating tape. Installation of aftermarket automotive electronics also often requires access to
special parts. It is a good idea to have a source for these common installation parts.
2 Inspect the vehicle and plan your work k
CHECK THE BATTERY
Test the battery voltage to make sure it’s fully charged and inspect battery terminals for tightness and any
corrosion. This takes 30 seconds and can save hours of troubleshooting later.
DECIDE ON A LOCATION FOR THE MAIN INTERFACE UNIT
Location of the main interface unit varies by vehicle, but is typically secured underneath a passenger seat
out of sight and unobstructed by moving parts and passengers.
(on page 5)
IF YOU HAVE PURCHASED A PRE-ASSEMBLED HEADREST SYSTEM, SKIP TO SECTION 6
To Next Page
Need help?
General
