Copyright 2015 All Rights Reserved
AV7950H Installation Guide GC1077 Rev A
Page 1
INSTALLATION GUIDE
AV7950H Dual Multimedia Headrest Replacement System
NOTICE OF INTENDED INSTALLATION AND USE E
AV7950H VIDEO PRODUCTS ARE NOT INTENDED FOR VIEWING BY THE DRIVER, AND ARE TO BE
INSTALLED ONLY TO BE VIEWED BY REAR-SEAT OCCUPANTS.
IMPROPER INSTALLATION COULD DISTRACT THE DRIVER OR INTERFERE WITH SAFE
OPERATION OF THE VEHICLE, WHICH COULD RESULT IN SERIOUS INJURY OR DEATH, AND
COULD ALSO VIOLATE STATE LAW. ROSEN ELECTRONICS DISCLAIMS ANY LIABILITY FOR ANY
BODILY INJURY OR PROPERTY DAMAGE THAT MAY RESULT FROM ANY IMPROPER OR
UNINTENDED INSTALLATION AND/OR USE.
BEFORE YOU START THE INSTALLATION, READ THIS GUIDE!
Rosen “Headrest Multimedia” systems are the easiest-to-install entertainment systems available today.
However, we strongly recommend reading this guide before starting the installation!
1 Make sure you have the tools you will need
These common items are needed to complete this installation:
· Digital multimeter (DMM) · #2 Phillips screwdriver
·
Appropriate tool for headrest removal
·
Allen wrench set
·
Panel removing tools
·
Cable routing tool (included)
·
Security latch tool (included)
·
Retractable knife
·
Wire cutters, strippers, and a crimping tool
·
1/4” drive sockets are often needed for dashboard and trim disassembly
·
Check if Torx or Allen-drive bolts are used on any panels you will be removing
·
You will need a DVD disc
in good condition
when testing the system
Standard installation parts you will need include wire, wire ties, wire crimp connectors or solder, and
electrical insulating tape. Installation of aftermarket automotive electronics also often requires access to
special parts. It is a good idea to have a source for these common installation parts.
To Next Page
Need help?
General
