Rosenbauer DIGIDOS 24 AT - Foam Intake; Changing Proportioning Rate Values

Seite - 50 -
04.10.2008 / LSV - JWh/ Rev. 02
DIGIDOS 24 AT
© 2008
OPERATION
Foam intake, changing proportioning rate
values
3.6 Foam Intake
To do this, press function key F5 (Foam intake) until foam
compound is output constantly through the ventilation line. The
message „Direct injection foam proportioning system in
suction mode or start-up mode!“ appears during this
procedure.
3.7 Changing the Preset Proportioning Rate Values
If you press keys F2 and F3 simultaneously, a window for
setting the preset proportioning rate appears. Using „+“ and
„-“, this can be changed to the desired value for the
corresponding tank or for external drafting.
Direct injection foam proportioning
system
in suction mode
or start-up mode!