Rosenbauer FLF 15000 PANTHER - Roof Turret Operation Stopping

Page - 55 -
FLF 15000/1800/500
Panther 8x8 CA-7
© 2014
8%
3%
Air Crash Mode
Stopping of turret operation:
◊ Press switch (S18) again - the turret is flushed automatically
when continuing water discharge.
◊ Release switch (S50) or press activated switch (S488).
◊ The pump engine will idle.
◊ Press "STOP"-switch (S47).
The turret moves to it's transport position.
◊ Disengage the pump - please refer to the "Engaging the
Pump" chapter.
ATTENTION !
On designs without a turret pipe, AFFF foam compound should be
used, otherwise the foam quality is poor ! *
The pump system must be flushed after every foam operation.
Please refer to the "Flushing after Foam Operation" chapter.
Operate the roof turret with closed roof hatch only !
S488 S50S47
S18