Page - 6 -
FLF 15000/1800/500
Panther 8x8 CA-7
© 2014
Technical Data
ATTENTION !
Always use similar tyres when chang-
ing or replacing a tyre to allow maxi-
mum driving performance!
It is strictly prohibited to use retreaded
tyres.
When changing the tyre type call for
written approval from Rosenbauer.
For further technical data please refer
to chassis operation manual.
Technical Data
Chassis
Type: RBI 52.1250 8x8 CA-7 RHD
Engine: 2 x CAT C 18 Tier 3
Performance: 2 x 470 kW at 1800 - 2100 rpm
Voltage of consumers: 24 Volt
Batteries engine I: 2 x 12 Volt / 180 Ah
Batteries engine II: 2 x 12 Volt / 180 Ah
Generator: 2 x 28 Volt / 140 Ampere
Transmission: 2 x Allison 4800 R with Retader
with collectivetransfercase (cTv)
Power Take Off (P.T.O.)
for N 100 pump: on collectivetransfercase
Ratio: n
engine
x 1.48
Rotating direction: counterclockwise
Performance: 310 kW at 2300 rpm
(engine speed)
Wheel base: 1600 mm + 5000 + 1600 mm
Tyres: Michelin 445/80 R 25 XGC
Powered axle: 8 x 8 permanent
Cabin: 1 + 1 + 1 + 1 + 2 men
Dimensions: Length ......................... 13100 mm
Width ............................ 3350 mm
Height ........................... 3650 mm
Permissible weight: Front axle I .......................13000 kg
Front axle II............................13000 kg
Rear axle I ........................13000 kg
Rear axle II .......................13000 kg
Gross vehicle weight ..........52000 kg
Ramp angles: Angle of approach ..................... 30
°
Ramp angle .............................. 12
°
Angle of departure ..................... 30
°
ATTENTION !
The vehicle should be operated by
trained and certified personnel.
When driving on inclines, uneven or
slippery roads / surfaces, as well as
during cures or expecting a lane change,
a prudent and precautionary driving
style should be used.
The instructions in the chassis opera-
tors manual should be strictly followed,
in particular when driving in off-road
conditions.
To Next Page
Loading...