Page - 61 -
FLF 15000/1800/500
Panther 8x8 CA-7
© 2014
Air Crash Mode
S219
S292
S81f
S291
S218
S81s
19
H94
Bumper turret RM 15 C oscillator operation *
The bumper turret is equipped with an oscillating mode, which
means the turret moves automatically within a preprogrammed
area.
- Operate the bumper turret as mentioned in the
◊
"Bumper turret operation with water" or
◊
"Bumper turret operation with foam" chapter.
- Press "START"-switch (S218).
◊
The bumper turret moves automatically to the preprogrammed
"attack position".
◊
The position LED (H94) illuminates.
- Move the turret to the desired oscillation center.
- Start the oscillating operation:
◊
Press switch (S291).
◊
The pilot lamp in switch (S291) illuminates.
◊
The turret moves automatically according to the prepro-
grammed oscillation area and velocity.
- The oscillation center can be adjusted by using joystick (19).
- To finish the oscillation mode press "START"-switch (S218);
continue with normal turret operation
or
press "STOP"-switch (S219).
◊
The turret moves to it's transport position.
Programming the oscillation working area and velocity:
- Adjust oscillation working area:
◊
Start the oscillation mode as described above.
◊
Keep the turret's discharge valve closed.
◊
Move the joystick (19) to desired direction and value corre-
sponding to the oscillation area, then press switch (S292).
Moving the joystick to the left -> the horizontal oscillation distance decreases.
Moving the joystick to the right -> the horizontal oscillation distance increases.
Moving the joystick forward -> the vertical oscillation distance decreases.
Moving the joystick backward -> the vertical oscillation distance increases.
◊
Press switch (S81s) to increase or (S81f) to decrease the
oscillating velocity, then press switch (S292).
◊
Press switch (S291) and (S292) simultaneously to save the
oscillation working area and velocity.
To Next Page
Loading...