Page - 62 -
FLF 15000/1800/500
Panther 8x8 CA-7
© 2014
8%
3%
Air Crash Mode
ATTENTION !
The pump system must be flushed after every foam operation.
Please refer to the "Flushing after Foam Operation" chapter.
Undertruck Nozzles
- Operate pump in automatic mode (base setting):
◊
The integrated pilot lamp in switch (S54) is off.
- Engage the pump:
◊
Please refer to the "Engaging the Pump" chapter.
- When the pump is engaged the following program starts:
◊
The water tank suction valve opens automatically.
◊
The priming pump is engaged automatically until a pressure
of 2 bar is achieved (visible on water pressure gauge (P6))
and the engine speed increases.
◊
The pump icon (J1) illuminates blue as long as the priming
pump is engaged.
◊
After achieving a pressure of 2 bar the engine speed decrease
to idle.
- Water operation:
◊
Open the undertruck nozzles discharge valve - press switch
(S19).
◊
Pump speed is increased automatically to half speed, as soon
as the undertruck nozzles discharge valve is opened.
- For foam operation additionally:
◊
Open the foam compound tank suction valve - press switch
(S18).
◊
The pilot lamp in switch (S18) illuminates.
◊
If required change the foam proportioning rate - press switch
(S14/1) if 3% or (S14/3) if 8% is required otherwise 6% foam
proportioning rate will be created.
Stopping of operation the undertruck nozzles:
- Close the foam compound tank suction valve:
◊
Press switch (S18) again.
◊
Continue operation with water to flush the system.
◊
Press switch (S19) again.
◊
The pump engine will idle.
◊
Disengage the pump - please refer to the "Engaging the
Pump" chapter.
xx,x bar
xxxx U/min
x %
xx °C
xxx h
S54
S14/1
S19 S18 P6 J1
S14/3
To Next Page
Loading...