Page - 84 -
FLF 15000/1800/500
Panther 8x8 CA-7
© 2014
Filling the foam compound tank with the electric foam compound
pump
- Connect drafting connection (J66) of the foam compound pump
to the external foam compound container.
- Turn three-way ball valve (J60) to tank fill mode "inside"
position.
- Open the external foam compound container supply valve.
- Turn switch (S168) to the "left" position.
◊
Turn switch (S168) to the left until pump is turning then
release switch (S168).
◊
The foam compound pump will automatically disengage,
when the tank is full.
- Observe foam compound level in the external foam compound
container!
Never run pump without foam compound!
- When the external foam compound container is empty or the
foam tank is full return switch (S168) to the "0" position and turn
three-way ball valve (J60) to the "transport" position.
- Flush the foam compound pump after each use!
◊
Please refer to the "Flushing of the electric foam compound
pump" chapter in this manual.
- Always provide connections (J51) and (J66) with blind cou-
plings.
Note:
Operate the engine with high idle speed to keep capacity of the
batteries in good condition. This should be done when electric fill
pump is engaged longer than 5 minutes.
Filling the Foam Compound Tank
ATTENTION !
Before beginning foam compound tank filling ensure that the drain
valve is closed.
The foam compound pump must be flushed after each use!
S168 J60 J66
J51
To Next Page
Loading...