Page - 94 -
FLF 15000/1800/500
Panther 8x8 CA-7
© 2014
Pneumatic Installation
Emergency Adjustment of the Foam Proportioning Rate
If an electric foam proportioning adjustment motor will not open/
control the foam proportioning valve, it can be disconnected and
the valve concerned can be controlled manually.
Procedure:
- Remove bolt (Z78) on top end of defective adjustment motor.
- Lift the motor together with the linkage to open the foam
proportioning valve concerned.
Note:
Initial position: foam proportioning adjustment motor fully ex-
tended -> foam proportioning valve closed
In case of emergency it is sufficient to open completely the big valve
only.
Z78
To Next Page
Loading...