REQUIRED TOOLS
LEVEL
TAPE MEASURE
LANDSCAPE
ADHESIVE
BELVEDERE FIRE PIT
QUICK INSTALL TIPS
Thank you for choosing Rosetta hardscape products. The following
are some helpful tips to make your first installation go smoothly. For
more in-depth technical information, see our Rosetta Technical Guide
(available at rosettahardscapes.com) or contact Rosetta Tech Support.
Your safety is important to us. Please follow OSHA guidelines, and
utilize safety-toe boots, hardhats, gloves and eye, ear & respiratory
protection whenever appropriate.
PATIO TOP INSTALLATION
• Fire pits should never be installed atop a patio surface. Rather, the fire
pit should be “cut in” to the patio surface to avoid damage to the patio.
SETTING THE PROPER CIRCUMFERENCE
• Place the steel liner, lip-side down, at the point of installation. Build
the base layer around this liner to approximate proper circumference.
Adjust the circumference as necessary. Remember to flip the steel liner,
lip-side up, after completing the first row of block.
PATTERN
• Follow the attached block layout pattern to build the fire pit.
SECURING THE COPING
• Adhere the coping to the top row of block with landscape adhesive.
VENTILATION CLEARANCE
• On the finished fire pit, the steel liner should rest approximately ¼”
below the coping. This will allow for proper heat dispersal, extending the
life of your fire pit.
Rosetta Tech Support: (231) 675-4979 • www.rosettahardscapes.com
To Next Page
Need help?
General
