Installation Guide
Unscrew the 4 screws to remove side panel. Install the motherboard and secure with the screws.
Take out the PCI slot cover.
Install the display card and secure with tolless screws.
Place the power supply from the left side into the
chassis and secure with the screws.
Install stand-offs by
stand-off socket.
Pull out the display card protection bracket to support
the display card. (support 260-320mm display card)
Squeeze and take out the optical drive block panel.
Insert the optical drive into position.
Install the 3.5” and 2.5” HDD onto the HDD toolless.
Insert the 3.5” HDD into position.
Insert the 2.5” HDD/SSD into position.
01 04
02 05
03 06
07 10
08 11
09 12
User’s ManualLegacy QT01
CASE
User’s ManualLegacy QT01
CASE
4
© All rights reserved by Rosewill
5
© All rights reserved by Rosewill
To Next Page
Loading...
