What to do if my ROSIERES TRIPLE 10 G Kitchen Appliances machine is completely dead?
If your ROSIERES Kitchen Appliances machine is completely dead, start by ensuring the electric plug is correctly connected. Next, verify that the O/I button has been pressed. Check that there is electricity supply. Finally, make sure the door is closed properly.
Why is the load of dishes only partially washed in my ROSIERES TRIPLE 10 G?
If your ROSIERES Kitchen Appliances dishes are only partially washed, make sure that burnt-on food remains are soaked off of pans before placing them in the dishwasher. Reposition the saucepans. Remove the spray arm by unscrewing the ring nut clockwise and wash it under running water if the spray arm is blocked. Ensure that the dishes have not been placed too closely together. The end of the outlet hose must not come into contact with the outflow water. Increase the amount of detergent used, especially if the dishes are very dirty, and replace old or hardened detergent. Tighten the salt dispenser tap fully. Finally, select a more vigorous wash program.
What to do if my ROSIERES TRIPLE 10 G machine does not draw water?
If your ROSIERES Kitchen Appliances machine does not draw water, first check that the water tap is turned on. Then, ensure the program selector is in the correct position. Next, make sure the inlet hose is not bent, and finally, clean the filter at the end of the inlet hose.
What to do if my ROSIERES TRIPLE 10 G Kitchen Appliances machine does not discharge water?
If your ROSIERES Kitchen Appliances machine does not discharge water, begin by cleaning the filter. Check to ensure the outlet hose is not kinked and straighten it if necessary. Make sure the outlet hose extension is correctly connected according to the instructions. If the outlet connection on the wall is pointing downwards instead of upwards, call a qualified technician.
Why are there white spots on dishes from my ROSIERES Kitchen Appliances?
If you observe white spots on dishes from your ROSIERES Kitchen Appliances, it may be due to the water being too hard. Check the salt and rinse aid levels, and adjust the amount accordingly. If the issue continues, contact a service center.
Why is there noise during wash in my ROSIERES TRIPLE 10 G?
To address a noisy wash cycle in your ROSIERES Kitchen Appliances, ensure the dishes are properly loaded onto the basket to prevent them from knocking against each other. Also, check that the revolving arm does not hit the dishes.
Why does my ROSIERES Kitchen Appliances machine discharge water continuously?
If your ROSIERES Kitchen Appliances machine discharges water continuously, lift the outlet hose to at least 40 cm above the floor level.
Why is the spray arm not heard to rotate in my ROSIERES Kitchen Appliances?
If the spray arm is not heard to rotate in your ROSIERES Kitchen Appliances, you may be using an excessive amount of detergent, so reduce the amount. Also, check to see if any item prevents the arm from rotating. Clean the plate and cup filter, if they are very dirty.
What does it mean when the 'Eco' indicator light and indicator light 'No 1' are on with an audible signal on my ROSIERES TRIPLE 10 G?
If the 'Eco' indicator light and indicator light 'No 1' are on, accompanied by an audible signal on your ROSIERES Kitchen Appliances, turn off the appliance, turn on the water tap, and then reset the cycle.
How to improve drying in ROSIERES TRIPLE 10 G?
To improve drying in your ROSIERES Kitchen Appliances, leave the dishwasher door ajar at the end of the wash program to allow dishes to dry naturally by improving air flow.
General| Brand | ROSIERES |
|---|---|
| Model | TRIPLE 10 G |
| Category | Kitchen Appliances |
| Language | English |
To Next Page
