Ross Acuity 4810AR-002 - Specifications - Port Pinouts; Peripheral Port Pinouts; Remote Port Pinouts; External Link Ports

Table 22: Peripheral Port Pinouts
RS-422RS-232Pin
Odd/Even Tx+n/c1
Tx-Rx2
Rx+Tx3
GroundGround4
GroundGround5
Odd/Even Tx-n/c6
Tx+n/c7
Rx-n/c8
5V 1K Pull-upn/c9
Table 23: Remote Port Pinouts
RS-422RS-232Pin
n/cn/c1
Rx-Tx2
Tx+Rx3
GroundGround4
GroundGround5
n/cn/c6
Rx+n/c7
Tx-n/c8
5V 1K Pull-upn/c9
External Link Ports
12345678
Figure 29: External Link Port (female)
Table 24: External Link Port Pinouts
SignalPin
Rx+1
Rx-2
Tx+3
PMC_SDI_Load+4
PMC_SDI_Load-5
Tx-6
PMC_SDI_Latch+7
PMC_SDI_Latch-8
GPI Ports
There are GPI ports located on two types of boards in
the frame. The GPI I/O port is located on the Frame CPU
board in slot A, and the GPIO ports are located on the
Reference with Tally board in slot G in the 4RU frame
and slot L and M in the 8RU fame.
12345678910111213
141516171819202122232425
Figure 30: GPI Port (female)
Table 25: GPI I/O Port Pinouts
SignalPin
Ground1
n/c2
n/c3
GPI In 104
GPI In 95
GPI In 86
GPI In 77
GPI In 68
GPI In 59
GPI In 410
GPI In 311
GPI In 212
GPI In 113
n/c14
n/c15
GPI Out 1016
GPI Out 917
GPI Out 818
GPI Out 719
GPI Out 620
GPI Out 521
GPI Out 422
GPI Out 323
GPI Out 224
GPI Out 125
Table 26: GPIO Port Pinouts
SignalPin
Ground1
GPI I/O 12
112 • Specifications — Acuity Setup Manual (v9.2)