Ross Acuity 4810AR-002 - Color Corrector Management; To Default a Color Corrector; Copying and Pasting Color Correctors

To Default a Color Corrector
1. Double-press a source button for the color corrector
that you want to default.
2. Press More.
3. Press Default Bus & Inputs or Default All
Inputs to default the selected color corrects.
• Default Bus & Inputs — default the color
correctors assigned to the current source or bus.
• Default All Inputs — default all color
correctors.
4. Press Confirm.
Copying and Pasting Color
Correctors
Once you have applied Proc Amp and RGB Color
Corrector adjustments to a specic input or video bus,
you can copy these settings to other inputs or buses.
To Copy and Paste a Color Corrector
1. Double-press a source button for the color corrector
that you want to copy.
2. Press More.
3. Press Copy Input to copy an input based color
corrector, or Copy Bus to copy a bus based color
corrector.
4. Toggle LOCK to on. This locks the menu system
to the current menu.
5. Press a different source button to select the source
or bus that you want to copy the color corrector
settings to. The current selection is shown in the
upper left corner of the menu.
6. Press Paste Input or Paste Bus to paste the color
corrector setting.
A new color corrector is assigned if one was not
already assigned to the input or bus.
7. Toggle LOCK to off.
82 • Color Correction — Acuity Setup Manual (v9.2)