Ross Carbonite Series - Memory Functions; To Set the Transition Type Attribute; To Set the Next Transition Attribute; To Set the Run Auto Trans Attribute

3.
Use the ME knob to select the ME, MiniME
™
, or
MultiScreen output that you want to set the attribute
for.
4.
Use the Value knob to select how the sources
selected on the preset bus are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — sources are not recalled on the preset
bus
•
Recall — sources are recalled on the preset bus
(default)
To Set the Transition Type Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select Trans.
3.
Use the ME knob to select the ME, MiniME
™
, or
MultiScreen output that you want to set the attribute
for.
4.
Use the Value knob to select how the next transition
type and parameters are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — transition selections are not recalled
•
Recall — transition selections are recalled
(default)
To Set the Next Transition Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select NextTr.
3.
Use the ME knob to select the ME, MiniME
™
, or
MultiScreen output that you want to set the attribute
for.
4.
Use the Value knob to select how the next transition
area is recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — next transition area settings are not
recalled
•
Recall — next transition are settings are recalled
(default)
To Set the Run Auto Trans Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select RnAuto.
3.
Use the ME knob to select the ME, MiniME
™
, or
MultiScreen output that you want to set the attribute
for.
4.
Use the Value knob to select whether a transition
is performed after the memory is recalled.
•
Memory — settings come from the memory
being recalled
•
NoRun — a transition is not performed after
the memory is recalled (default)
•
Run — a transition is performed after the
memory is recalled
To Set the Shared Pattern Generator Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select SrdPat.
3.
Use the ME knob to select the ME output that you
want to set the attribute for.
4.
Use the Value knob to select whether the settings
for the shared Key Mask/Wash pattern generator is
recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — shared pattern generator settings are
not recalled
•
Recall — shared pattern generator settings are
recalled (default)
To Set the Key Bus Sources Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select KeyBus.
3.
Use the Key knob to select the keyer you want to
set the attribute for.
4.
Use the Value knob to select whether sources
selected on the selected key bus are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — sources are not recalled on the key
bus
•
Recall — sources are recalled on the key bus
(default)
To Set the Key On-Air Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select KActiv.
50 • Memory Functions — Carbonite Operation Manual (v13.0)