Animation Controls
The MediaManager interface allows you to manually
control the play-out of an animation.
Figure 25: Media-Store Channel — Animation Controls
Table 5: Animation Controls
DescriptionNameIcon
Play the animation loaded in
the Media-Store channel.
Play
Turns Looping of the
animation on or off.
Looping
Toggle the direction that the
animation is played in.
Reverse
Loads the animation again.Recue
Eject the current still or
animation from the Media-Store
Eject
channel. This is the same as
loading media number 000 on
the panel.
Playlists
Playlists allow you to create a rundown of stills or
animations that you want to load into a Media-Store
channel. Using the left and right arrows, you can advance
to the next or previous still or animation in the playlist.
Note: Items on the playlist are not pre-cached. As you advance
to the next item in the list, the switcher must load that still or
animation. Depending on what you are loading, and if the item
has been loaded before, this could take a few seconds.
Figure 26: Playlist
Table 6: Playlist Controls
DescriptionNameIcon
Advance to the previous item
in the playlist. The item in the
Previous
playlist that is being shown on
DescriptionNameIcon
the Media-Store channel
indicated with a check-mark.
The playlist does not loop back
to the top when it reaches the
last item.
Advance to the next item in the
playlist.
Next
Move the currently selected
item up in the playlist.
Up and Down
Move the currently selected
item down in the playlist.
Up and Down
Delete the selected item from
the playlist. This does not
Delete
delete the item, or clear the
Media-Store channel.
Clears the current playlist.New Playlist
Allows you to load, save, or
delete a playlist on the
Load or Save
Playlist
switcher. If you delete a playlist
that was loaded into a
Media-Store channel, it does
not clear that channel.
Expand or Collapse the playlist
area for the Media-Store
channel.
Expand or
Collapse
58 • Media-Store — Carbonite Operation Manual (v13.0)
To Next Page
Loading...
